Bimar VTM33 Bedienungsanleitung Seite 15

3. Couple the front grid (1) with the rear grid (5) and lock with the retention
hooks. For safety reasons, you must ensure the fastening with the appropriate
locking screw (12) in the holes provided on the edge of the grid, (the screw
holes must be in the lower part).
USE
Before each use, verify that the unit is in good condition, the electric cord is not
damaged, if the power cord is damaged, it must be replaced by the manufacturer
or a competent qualified electrician or a person with similar qualifications, in
order to avoid any risk.
Insert the plug of the fan in the power supply.
Ventilation: select the desired speed by turning the switch to one of the
following positions:
I– Minimum speed I I–Medium speed I I I–Maximum speed
To turn off, turn the switch to position 0 and then remove the plug from the
socket.
Horizontal oscillation (right-left): this is selected with the button located on the
motor body. To stop the motion and keep the ventilator still, press the button.
Vertical inclination (high-low): it is regulated by gripping the motor body and
orienting it in the direction desired; tighten the screw (9) to lock the motor
housing in the desired position.
When not in use for long periods, the plug must always be removed from the
socket.
15/40