Herunterladen Inhalt Inhalt Diese Seite drucken

Components; Monitor; Outdoor Station, Exterior Camera; Installing - Extel MEMO Installations- Und Bedienungsanleitung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 35

3. COMPONENTS

a. Monitor
1. 7" LCD colour screen (18 cm).
2. Microphone for communication with the outdoor station.
3. Video record button during a communication or when resuming an image
4. Door-opener control (12 VDC output on GND and COM terminals at the back of the camera or dry contact
on COM and NO terminals at the back of the camera
5. Surveillance or image resuming key + communication with the panel after a call
6. LED status indicator flickers red to indicate a passage at the time of an absence
7. Button +
8. Button
9. Button
10. Button –
11. Speaker: allows to be heard outside
12. Connection to camera
13. Connector by the 24 VDC plug of the adapter (adapter to connect to an installation compliant with standards
in force: NFC 15 100 in France
14. Dip1: OFF position one-second dry contact, ON position 3-second dry contact (for the control of an auto-
matic gate opener) - Dip 2 : not used (leave on OFF)
b. Outdoor station, exterior camera
1. Microphone: allows the visitor to communicate with the interior.
2. CMOS camera lens with automatic iris.
3. Visible infrared LEDs for low-light conditions; for use at night,
install a lighting system.
4. Speaker: allows to be heard outside
5. Luminescent name holder
6. Call button, when this button is pressed, the ring tone is heard
inside, the camera and the monitor turn on.
Access to name holder :
• Press the side of the name holder to access the label.
CFI EXTEL MEMO - V1 - 11/2011
GB4

4. INSTALLING

a. Installing of outdoor station, exterior camera
1. Remove the screw cover (1) and unscrew the 2 screws (3)
2. Fix the shield (4) taking care to let pass the cable coming from the monitor and the opening.
3. Connect the cable as shown in the wiring diagram
4. Hang the outdoor station on the pin (6) of the shield, and fix the whole using the screw (2)
5. Replace the screw cover (1) and the 2 screws (3).
Make sure that the camera lens is not pointing directly at the sun or at a reflective surface.
Important !
Seal the upper joint between the exterior plate and the wall with silicone (5)
b. Installing of monitor
1. Put the wall carrier (2) in place.
2. Connect the wires coming
from the outdoor station.
3. Connect the adaptor plug (3)
to the back of the monitor (without
connecting it to the power supply).
4. Fix the monitor (1) to the wall
carrier (2).
5. Check that the installation iscomplete
and connect the adaptor to the
power supply.
N.B. : If the power supply cable is cut, check the polarity (black wire and black wire with grey edging)
CFI EXTEL MEMO - V1 - 11/2011
GB5

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis