Installation Methods - Kenwood CS-7070ES Bedienungsanleitung

Installation Methods

On Floor or Shelf
Place the speaker on the floor or on a shelf or other horizontal
stable surface. Keep in mind that speaker is not fixed into place,
so be careful to avoid knocking it over.
On the Wall
This speaker include mount hole for wall mounting. You need to set two screws into the wall at the appropriate distance so that you
can hang the speaker from both mount holes. Proceed as follows.
1 Screw two screws into the walls 300 mm (11-13/16 inches) apart, making sure that screws are horizontally level.
Screw each screw only part way in, so that the screw projects 9 to 11 mm (3/8 to 7/16 inches) outward from the wall
surface.
300 mm
(11-13/16")
2 Hang the speaker by fitting the two mount holes (at the rear of the speaker) over the extending part of the screw.
Confirm that the speaker is held firmly and securely in place.
Precautions
Please observe the following precautions when mounting speaker onto the wall.
• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 3.0 kg [6.6 lb] ).
• Wall screws must be purchased separately.
• Be sure to use screws that are appropriate for the wall you are using, and that are long enough to provide sufficient
strength.
• If you are uncertain about the wall's support strength, the type of screw to use, or any other points regarding this
type of installation, please consult a contractor or other qualified person before proceeding.
Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injury
or damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficient
support strength.
9 - 11 mm
(3/8 to 7/16")
Mount hole
Cushion
• Wall screws must be purchased separately.
Cushion
• Attach each couple of provided cushions to make two sets
of two-cushion piles, and attach them to the two positions
shown on the rear of the speaker. These piles will protect
the speaker body from damage and prevent the vibrations
of the speaker body from being transmitted to the wall.
• Attach four cushions to the base
of the speaker, one at each corner.
The cushions prevent the speaker
from sliding, and dampen its vibra-
tions.
3
EN