Operation; Emptying The Product; Deflating The Product - Crivit HG02051 Bedienungs- Und Sicherheitshinweise

Operation

Note: Before using the product for the first time,
check it carefully for holes, porous places and seams
that are not airtight.
Recommendation: Pump the product up and
leave it alone for one day. Let a new product air
outside in fresh air for a couple of days.
Recommendation: Place the activity toy on a
level surface at least 2 m from any structure or
obstruction such as a fence, garage, house, over-
hanging branches, laundry lines or electrical wires.
Pumping up the product
CAUTION! Inflatable plastic products react sensi-
tively to the cold and hot. That is why you should
never use the product when the ambient temperature
falls to below 15 ° C and rises above 40 ° C.
Otherwise damage to the product may result.
Note: Basically, only an adult should be responsible
for pumping the pool up. Make sure that you do
not pump too much air into the product. On no ac-
count should you use a compressor. Stop the process
when resistance increases during pumping and the
seams start to stretch. Otherwise the material might
tear. Only use manual pumps and / or pumps specifi-
cally designed for use with inflatable plastic products.
IMPORTANT! Keep in mind that air temperature
and weather conditions can affect the air pressure
inside inflatable products. In cold weather the prod-
uct behaves as if it has less air pressure in it because
the air inside contracts. Under these conditions you
may have to add air. In hot weather the air inside
expands. Under these conditions you may have to
remove air in order to avoid overfilling.
Note: You will need a pump with conical ad-apter
(ø approx. 7.5 mm / 17.5mm) for the air valve to in-
flate the product.
R oll the product out first and then check for
holes, tears and other damage.
6 GB
1. Inflate the main chambers
Inflate the main chambers and close the seal-
ing cap (see fig. C). Inflate the main chambers
until they feel firm to the touch. It should be
1 a
possible to depress each main chamber
slightly by pressing it with your fingers.
2. Inflate all the rest parts:
Open the valve and inflate the air chambers.
Close the valve closure and depress the valve
using slight pressure (see fig. D).
3. Attaching the slide
Place the inflated slide
paddling pool. Fix the slide
edge of the paddling pool and to the floor.
Insert the four pins in the relevant eyelets on
the paddling pool and ensure that these are
inserted fully through the eyelets (see fig. E).
4. Attaching the ball track
Place the inflated ball track
the paddling pool and attach all three hook-
and-loop fasteners.
5. Attaching the garden hose:
Connect a garden hose with an interior diame-
ter of 13–15mm to the water connector on the
article (see fig. F). We recommend the use of a
hose coupling 13–15mm for easy assembly.
Filling the product with water
F ill the product slowly and do not leave the
product unsupervised during filling.

Emptying the product

O pen the outlet valves and allow the water to
drain out (see fig. G).
Note: please take the local regulations into
account regarding specific requirements on the
disposal of water from swimming pools.

Deflating the product

R emove the garden hose. Remove the ball
track and the slide
3
:
1 a
1 a
:
2
on the edge of the
2
to the upper
2
:
3
on the edge of
3
.
2