Velleman WS8818 Bedienungsanleitung Seite 8

The upper part displays the outdoor temperature (left) and relative humidity
(right).
The lower part displays the indoor temperature (left) and relative humidity
(right). The functions for the outdoor and indoor values are identical except
for the switching units.
5.9 Switching Sensor Units
Open the battery cover of the sensor and assign a number to the sensor.
Remember to assign a different number to each of the connected sensors.
The receiver accepts maximum three different sensors.
Press [ ] to switch between the different connected sensors.
automatic sensor switching
5.10 Max/Min Mode
Press [MAX/MIN] to toggle through the maximum, minimum and current
temperature/pressure values for the last 24 hours.
5.11 Trend Arrows
The trend arrows are updated every 30 seconds.
5.12 Selecting Temperature Units
In normal mode, hold [°C/°F] pressed to select your temperature units.
5.13 Re-Synchronizing after Signal Loss
In normal mode, hold [
hygrometer. Wait and do not touch any button until synchronization is
complete.
If synchronization has failed, please remove the power from the receiver
console, re-power and wait for the DCF-signal to recover.
5.14 Re-Synchronizing the Outdoor Sensor
In normal mode, hold [
V. 01 – 07/07/2017
rising
] pressed to re-synchronize the thermo-
] pressed to re-synchronize the sensor(s).
WS8818
currently selected sensor
8
falling
©Velleman nv