HQ Power VDPLP64SB Bedienungsanleitung Seite 5

5. Use
• Auto: DIP switches as below (X means ON, 0 means OFF)
Mode Dip10 Dip9 Dip8 Dip7 Dip6 Dip5 Dip4 Dip3 Dip2 Dip1
Auto run
(master 0
projector)
Sound
activated
0
(master
projector)
DMX 1
1
Other
1
• DMX512 mode:
Press 10 to ON to receive the DMX signal. 1-9 are used to select the requested address.
1 2
1 2
Example: If the start address should be 95 the settings would be (for switches 1-10): 1111101000 (1 + 2 + 4 + 8 +
16 + 0 + 64 = 95).
This unit has 4 channels. Refer to the functions below:
Ch 1: 0-255 Red dimmer
Ch 2: 0-255 Green dimmer
Ch 3: 0-255 Blue dimmer
Ch 4: 0-189 Dimmer
190-250 Strobe
251-255 No function
DMX512 Connection
Connect an XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-pin XLR
input of the VDPLP56SB / VDPLP56SC. Multiple VDPLP56SB / VDPLP56SCs can be linked through serial linking.
The linking cable should be a two-core screened cable with XLR input and output connectors.
VDPLP64SB / VDPLP64SC_v2
X X 0
0
0 0 X
1 X X X
X X X X
0 0 0 0
0 0 0 0
3 4
4 8
0 0 0
X X X
X X X
X X X
0 0 0
0 0 0
5 6
16 32 64
5
Colour changing and fading.
0 0 Select running speed via dip
Static colour and flash. Select
X X colour via dip 1-3, and flash
speed via dip 4-6.
Sound-activated colour
X X
DMX mode
CH1 → R CH2 → G
X X
CH3 → B CH4 → Dimmer,
1. DMX address is 1 when in
DMX mode.
0 1
2. As slave projector when in
M/S mode.
0 0
7 8 9
128 256
Function
7-8.
change.
strobe
Black-out
10
*
VELLEMAN