Introducing Your Cat To The Litter Box; Changing The Litter Tray - Petsafe ScoopFree PAL19-14657 Gebrauchsanweisung

Use the Manual Button
Although the Litter Box is designed to operate automatically, you can manually control the Rake by pushing the Manual Button (
the Litter Box.
1. Push once to start the Rake cycle.
2. Push again to stop the Rake cycle.
3. Push one more time to return the Rake to the Home position.
If the Rake is stopped somewhere other than the Home position, press the Manual Button to reset the cycle and return the Rake.

Introducing Your Cat to the Litter Box

Some cats may require an adjustment period to acclimate to a new litter box. Here are a few tips to help with the transition:
• Place the new Litter Box next to your cat's old litter box.
• Allow your cat to have access to both the old and new litter boxes for at least a week. This time may vary based on the temperament of your cat.
• You may want to leave the system unplugged to allow your cat to use the new Litter Box without any distractions.
Note: You must manually scoop solid waste from the Litter Box during the transition.
• Allow your cat's old litter box to remain dirty. Cats prefer a clean litter box and this will make the new Litter Box more appealing.
• Add a few handfuls of Crystal Litter to your cat's old litter box before transitioning to the new Litter Box. Add a few small handfuls of your cat's
old litter to the Crystal Litter Tray after the transition.
• Once your cat is acclimated to the new Litter Box, plug in the system and remove the old Litter Box from the area.

Changing the Litter Tray

Do not add litter or remove solid waste during normal operation. The Crystal Litter will remain clean for weeks at a time. See the chart below for the
recommended Litter Tray replacement schedule.
Note: Please see page 2 for important safety information.
1. Gently shake the Litter Box to reduce Crystal Litter that may have accumulated behind the Rake. This
will reduce or prevent spillage that may occur when lifting the Litter Box Frame.
2. Lift the front of the Litter Box Frame until it is standing on its end (A) and remove the Litter Tray.
3. Remove the cover from under the Litter Tray and place it on top of the Litter Tray (B). Secure with tape
if desired or place within a drawstring rubbish bag.
4. Dispose of the used Litter Tray.
5. Install a new Litter Tray as shown in the "Install the Litter Tray" section.
If solid waste is collecting outside of the Waste Compartment, it is time to change the Litter Tray.
Recommended Litter Tray Replacement
1 Cat 20 − 30 days
2 Cats 10 − 15 days
3 Cats 7 − 10 days
.
www.petsafe.net
) on the top of
A B
7