Panasonic WV-Q126E Handbuch Seite 6

3. Mount the safety wire angle (accessory) on the 2nd anchor bolt and connect the safe-
ty wire (accessory) to the angle.
1
Disconnect the safety wire from the
safety wire angle.
2
Engage the face marked
anchor bolt.
3
Bend the face marked
4
Connect the safety wire to the safety
wire angle again.
Note: To use the anchor bolt that was already installed, the use of 2 spacer nuts is helpful.
4. Remove the camera mounting stage.
1
Remove the 6 screws (M4).
2
Rotate the camera mounting stage
a half-turn clockwise.
3
Lift the camera mounting stage and
remove it.
6
1 with the
2.
Spacer nuts
Anchor bolt
2 Insert
1 Disconnect
Safety wire
Mark 1
Safety wire angle
Safety wire
1
1
2
1
Upper side
Mark 2
3 Bend
Lower
side
4 Connect
Spacer nuts
Safety wire angle
Existing anchor bolt
3
Screw (M4) × 6
1
2
2
Camera
1
mounting
1
stage