Initial Use - Beurer BM 51 easyClip Gebrauchsanweisung

6. Initial use

Inserting the batteries
• Remove the battery
compartment lid on the rear
of the device.
• Insert four 1.5 V AA (alkaline
type LR6) batteries. Make
sure that the batteries are
inserted the correct way round
in accordance with the markings. Do not use rechargeable
batteries.
• Carefully close the battery compartment lid again.
• All display elements are briefly displayed,
the display. Now set the date and time as described below.
If the battery replacement symbol
displayed, you can no longer perform any measurements
and must replace all batteries. Once the batteries have been
removed from the device, the date and time must be set again.
Any saved measured values are retained.
Setting the hour format, date and time
It is essential that you set the date and time. Otherwise, you
will not be able to save your measured values correctly with
a date and time and access them again later.
4x 1.5 V AA (LR6)
flashes in
is permanently
25
There are two different ways to access the menu from
which you can adjust the settings:
• Before initial use and after each time you replace the battery:
When inserting batteries into the device, you will be taken to
the relevant menu automatically.
• If the batteries have already been inserted:
Press and hold the SET setting button on the device
for approx. 5 seconds with the device switched off.
In this menu you can adjust the following settings in
succession:
Hour format
The hour format flashes on the display.
- +
• Use the / function buttons to select the
relevant hour format and confirm using the
SET setting button.
The year flashes on the display.
- +
• Using the / function buttons, select the
relevant year and confirm using the SET
setting button.
The month flashes on the display.
- +
• Use the / function buttons to select the
relevant month and confirm using the SET
setting button.
Date Time
➔ ➔