Velleman K6713 Gebrauchsanweisung Seite 22

TEST AND USAGE
Connect the mains voltage to the points marked MAINS.
ATTENTIONS: CERTAIN POINTS OF THE CIRCUIT CARRY
MAINS VOLTAGE NOW.
Test the operation of the receiver by both operating the transmitter
(right channel) and pressing the local push button.
REMARK: The receiver may possibly not work when the distance
between transmitter and receiver is smaller than 1 metre.
The CLEAR key allows to switch all the receivers off at the same
time. You further have the following possibilities with the remote
control:
a) Fixing a memory:
Press the keys STORE and MEM1 or MEM2 simultaneously.
The receiver having accepted the memory confirms this by
flashing the relay (and the indication LED) for a while. This may be
handy when you have several receivers in the same room.
b) Calling a memory:
To call memory 1, press CALL1
To call memory 2, press CALL2
c) Making the memory of (a) given receiver(s) insensitive:
When using several receivers, it sometimes can be useful when
some of the receivers react to memory 1 only and others to
memory 2 only. This can be achieved by first pressing CLEAR
and then preserving this state in memory 1 or 2 of the respective
receivers (pay attention to the flashing of the light(s) indicating that
the new setting has been accepted). You have four receivers and
you have selected four different channels for operating the
receivers separately. However you would like receivers 1 and 3 to
react to memory 1 and NOT to memory 2, and receivers 2 and 4
to react to memory 2 and NOT to memory 1.
Proceed as follows:
- First switch all outputs off (CLEAR key)
H6713-ED1-22