Filling With Water - Philips HI 984 Gebrauchsanweisung

Table
Label with Kind of
ironing textile
instructions
Synthetic
e.g. acetate,
acrylic,
viscose,
B
polyamide,
polyester.
Silk
C
Wool
Cotton
D
Linen
Z
Please note: This article cannot be
ironed!
ironing temperature of the composition of
those fibres.
(E.g. an article consisting of "60% polyester
and 40% cotton" should be ironed at the
temperature indicated for polyester (
without steam.)
If you do not know what kind(s) of fabric(s)
the article has been made of, find a spot which
will be invisible when wearing or using the
article to try out the ironing temperature.
(Always start at a low temperature and
increase to one which gives the required
results.)
• Pure woollen fabrics (100% wool) may be
pressed with the iron set to a steam position.
It is recommended to apply shot-of-steam and
use a dry pressing cloth.
When steam-ironing woollen fabrics, shining
of the fabric may occur. This can be prevented
by turning the article inside out and ironing
the inside.
• Velvet and other textures which rapidly
acquire shiny spots should be ironed in one
direction only (with the nap), applying only
light pressure.
Always keep the iron moving.
• Iron the reverse side of synthetic materials
and silk to prevent shining spots. When
Temperature
Steam
dial
ironing
_
MIN
|
|
1
|
|
A
|
2
A
|
3
MAX
1 ) and
ironing coloured silk, it is not advisable to use
steam as this may cause stains.

Filling with water

- Position the steam tank on a stable flat surface
and unscrew the cap of the steam tank (E) by
turning anti-clockwise.
- Fill the steam tank with water (max. 1 litre)
(fig. 2).
2
• You can use tapwater. However, if the water is
very hard (hardness higher than 17 °DH /
21 ⁄ °Clarke), it is advisable to use distilled
1
4
water.
• Never use vinegar, descaling agents or other
chemicals.
- Close the steam tank by turning the screw cap
clockwise by hand until tight (fig. 3).
If you begin ironing
- Fill the steam tank before inserting the mains
plug into the wall socket.
While ironing
Caution: If heated-up, the steam tank will
be under pressure.
Only refill if the steam tank is empty (i.e.
when pilot light "Refill steam tank "
comes on.
4
- Switch the iron off by setting switch "Iron
on/off" ≥ (D) to position
- Switch the steam tank off by setting switch
"Steam tank on/off"
(fig. 5).
5
(for steam-ironing)
3
FILLING OPENING
WITH SCREW CAP
(O)
*
5
O (fig. 4).
(B) to position
≤ O