Auping AVS type vlak Gebrauchsanweisung Seite 26

The box spring fails to
respond to the remote
control
The box spring fails to
respond to the infrared
remote control
Infrared remote
control, lights blinking
The box spring fails to
respond to the remote
control with cable
Hinge defect
GB24
_04DU3_3903 - BW.pdf - pag.24
Cause
Wrong infrared channel.
The signal from the
handset is not being
picked up by the
receiver in the control
unit. The signal may fail
to reach the receiver if
the handset is a
substantial distance
from the control unit or
the latter is covered by
a duvet, for example.
Processor failure.
Ruptured wire in cable.
Transport failure.
LET OP !!! Lage resolutie!
Search
Check that the switch on
the remote control and
the switch on the control
box are set to the same
channel.
Check if the system
works by pointing the
handset directly at the
control unit beneath the
bed. Check if the control
unit has been fixed
properly.
Check cable at strain
relieve.
Solution
If not: switch one of the
switches to the correct
channel.
Remove the duvet or
blankets that may be
interrupting the signal.
Install IR preamplifier if
necessary.
Reset. Take batteries
out, push some buttons.
Put batteries in again.
Replace.
Replace upper frame.
January 23, 2009