Emptying The Dirt Collection Tank; Troubleshooting - Polti FORZASPIRA AG100 Gebrauchsanweisung

FORZASPIRA AG100 - AG130 - M0S10990 - 1Q09 - 2016:FEV 1000-950.qxd
USE
♦ Assemble the 28 cm window cleaning
frame. (B) or the small 17 cm window clea-
ning frame (O)*, based on the size of the
surface to be cleaned, to the base until it is
hooked (Fig. 2).
♦ Clean the window.
♦ Turn on the appliance by moving the switch
forward (E) (Fig. 3). The operating/recharge
(D) LED will turn on.
♦ Place the window cleaning frame on the up-
per part of the window and using a slight
pressure move downward (Fig. 4).
♦ Once the cleaning operation is finished,
turn off the appliance by moving the switch
backward (E).
(*) Only for Model AG130.
EMPTYING THE DIRT COLLECTION
TANK
When the Max level of dirty water is reached
in the tank (I), it must be emptied as follows:
♦ Turn the appliance off.
♦ Pull the tank stopper (H) (Fig. 5).
♦ Tilt the tank so that the dirty water can
come out (Fig. 6).
♦ Replace the tank stopper.
♦ Resume cleaning operations.
WARNING: If the maximum filling level is
exceeded, small quantities of water can
leak out of the ventilation slots. Always
empty the tank before the maximum filling
level is reached.
PROBLEM
The appliance won't turn on
FORZASPIRA AG100 - AG130
CARE OF YOUR APPLIANCE
• Before performing any maintenance
operation, make sure that the appliance
is off and/or disconnected from the
mains.
• To clean the body of the appliance, simply
use a moist cloth. Do not use solvents or
detergents which may harm the body mate-
rial.
• The cloths provided can be washed by fol-
lowing the instructions included on the label.
CLEANING OF THE WINDOW CLEANING
♦ Release the window cleaning frame and re-
move it from the base (Fig. 11).
♦ Rinse the frame (B) - (O)* under running
water and let it dry.
(*) Only for Model AG130.
CLEANING THE TANK UNIT (J)
♦ Remove the tank unit (I) (Fig.12), empty it
(see paragraph "Empty water from tank").
Unscrew the tank stopper w/filter (I2) and
squeeze it (Fig. 13), after which rinse all the
components under running water and let
them dry.

TROUBLESHOOTING

CAUSE
Battery discharged
ON/OFF switch (E) is turned off
15
23/09/2016
FRAME (B) - (O)*
SOLUTION
Charge the appliance
Turn on the ON/OFF switch (E).
14.34 Pagina 15