CombiSteel 7464.0085 Gebrauchsanweisung Seite 7

Thermostat setting must be done according to the features of the products to be preserved. Temperature setting
can be done by means of turning the black thermostat knob on the control panel by the help of a coin or similar
object. Turning the knob right decreases the internal temperature, whereas turning it left increases the internal
temperature. Turning the knob left stops the compressor, which in turn stops the chilling process, although the
electric current to the cooler is not cut off.
Internal ventilation fan switch (optional):
It used to provide air circulation inside the cooler.
Internal lighting switch (optional):
It is used to turn on or off the internal light of your cooler. If the light bulb does not function anymore, always
unplug the cooler from the mains before replacing it. Pull up the lamp cover. Rotate the electric bulb 90 degrees,
take it off and replace it with a new one. Always replace the starter whenever you replace the electric bulb.
Canopy lamps and inside lamps of S88SC and S56SC can be replaced only by skilled persons.
Dismantling the illuminated advertisement panel
If it ever requires dismantling the illuminated advertisement panel, do the following:
The LEFT lid is screwed to the body and it is not possible to dismantle it from the outside.
Therefore do not try to remove it. Advertisement panel is fixed to the RIGHT lid. Hold the right lid on the top and
bottom sides and pull it RIGHTWARDS. The right lid will slide on the upper and lower tracks allowing the
compartment to open. Once the compartment is open, carry out the needed (replacing the florescent lamps)
and close the compartment by pulling the lid in the opposite direction.
Replacing the fluorescent lighting: (if your product has fluorescent lamp)
Before dismantling the lamp, always unplug your cooler. After dismantling the lamp cover inside the cooler,
remove the lamp and always replace it with a lamp of the same features (length, power, etc.)
7
www.combisteel.com