Operation - Toro 51594 Bedienungsanleitung

3. Install the vacuum bag.
4. Adjust the strap as needed for comfortable operation.
Converting from Vacuum to Blower
1. Remove the vacuum bag and the vacuum tube from the blower
housing.
2. Install the blower tube and then the inlet cover onto the blower
housing.
Important: The blower will not run unless the bottom inlet
cover is locked in place.

Operation

Important: This blower is intended for outdoor, residential use
only. Do not use it indoors or for commercial or industrial
purposes.
Connecting to a Power Source
The power supply you use with this appliance should be a residential
current device (RCD) with a tripping current of not more than 30 mA.
Use only a CE approved extension cord recommended for outdoor
use. Do not change the appliance or extension cord plug in any way.
If you do not fully seat the extension cord on the inlet plug,
or if the plug and cord do not fit firmly, the loose plug could
lead to overheating and cause a fire, possibly burning you
or others.
•
Ensure that you fully seat the cord on the plug.
•
Check the connection regularly to ensure that the cord is
firmly attached.
•
Do not use a worn-out or loose extension cord.
Extension Cord Length
30 m
45 m
Note: Do not use an extension cord over 45 m.
Important: Check the extension cord frequently during use for
holes in the insulation. Do not use a damaged cord. Do not run
the cord through standing water or wet grass.
4
Minimum Wire Gage
1.0 mm 2
2.0 mm 2