For The Customers In Canada - Sony WRT-847A Bedienungsanleitung

WARNUNG
Akkus dürfen keinesfalls übermäßiger Wärmeeinwirkung
ausgesetzt werden, wie z.B. Sonneneinstrahlung, Feuer o. ä.
Wenn der Sender eine abnorm hohe Temperatur, einen Geruch
nach Verbranntem oder Rauch entwickelt, entnehmen Sie den
Batterie-Halter und stoppen Sie sofort den Betrieb des Senders.
Achten Sie bei der Entnahme des Batterie-Halters darauf, sich
nicht die Finger zu verbrennen, denn die Batterien könnten sehr
heiß zu diesem Zeitpunkt sein.
ADVERTENCIA
No se deben exponer las baterías a una fuente de calor excesivo
como la luz del sol, el fuego o similar.
Si el transmisor desprende temperaturas altas no normales, olor
a quemado o humo durante su uso, quite el soporte de las pilas y
detenga el uso del transmisor inmediatamente.
Tenga cuidado de no quemarse los dedos cuando quite el
soporte de las pilas pues las pilas pueden estar bastante calientes
en este momento.
For the customers in the U.S.A.
Use of Sony wireless devices is regulated by the Federal
Communications Commission as described in Part 74 subpart H
of the FCC regulations and users authorized thereby are required
to obtain an appropriate license.
You are cautioned that any changes or modifications not
expressly approved in this manual could void your authority to
operate this equipment.
IMPORTANT NOTE: To comply with the FCC RF exposure
compliance requirements, no change to the antenna or the
device is permitted.
Any change to the antenna or the device could result in the
device exceeding the RF exposure requirements and void user's
authority to operate this device.
This device complies with the FCC radiation exposure limits
set forth for uncontrolled equipment and meets the FCC radio
frequency (RF) Exposure Guidelines in Supplement C to OET65.
This device has very low levels of RF energy that it is deemed to
comply without testing of specific absorption ratio (SAR).

For the customers in Canada

Use of Sony wireless devices is regulated by the Industry Canada
as described in their Radio Standard Specification RSS-123.
A licence is normally required. The local district office of Industry
Canada should therefore be contacted. When the operation of
the device is within the broadcast band, the licence is issued on
no-interference, no-protection basis with respect to broadcast
signals.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device.
The term "IC:" before the radio certification number only signifies
that Industry Canada technical specifications were met.
iii