Technical Specification - Pro-Ject Audio Systems Box-Design Box 10E Betriebsanleitung

Inhaltsverzeichnis

Verfügbare Sprachen

Technical specifications

Enclosure type

Recommended amplifier power:

Frequency response:

Nominal impedance:

Sensitivity:

Chassis:

Dimensions H x W x D:

Weight:

Potential incorrect use and fault conditions

No signal on one or both channels:

Make sure that amplifier is turned on and source is working properly.

No connection between speaker and amplifier. This could be due

to a faulty plug, broken wire or or simply loose plug/socket connection.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved, the unit be sent to

the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

For more information about Pro-Ject and Box Design, see our homepage:

http://www.project-audio.com/

Pro-Ject Speaker Box 10 E

bass reflex via rear firing port

10 to 150 watts

50Hz - 20kHz

4 ohms

90dB (1w /1m)

1" silk dome tweeter

4,5" paper cone bass/mid (2 pc.)

920 x 140 x 190 mm (excluding spike feet)

945 x 140 x 190 mm (including spike feet)

11,7kg each

Inhaltsverzeichnis