Using The Unit In Index Mode - Sony LMD-1041 Bedienungsanleitung

Using the unit in index mode

When more than two monitors are connected via the
CONTROL S connector, you can adjust all the connected
monitors simultaneously using the remote commander
(Normal mode).
If you want to adjust a specific monitor using the remote
commander, set the remote commander to the same index
number as the monitor (Index mode).
Adjusting a specific monitor
1 Press the INDEX button on the monitor you want to
adjust.
The index number of the monitor appears.
2 Press the ID ON button on the remote commander.
The index number of the remote commander appears.
3 Confirm that the index numbers of the monitor and
the remote commander are the same.
4 Press the SET button.
The on-screen display changes from green to yellow.
5 Begin adjusting (page 10).
6 When you finish adjusting, press the remote
commander's ID OFF button.
The monitor returns to normal mode.
If you press the SET button in step 4 when the
index numbers are different
The on-screen display changes from green to red.
PRESS ID ON KEY OR ID OFF KEY
ON COMMANDER
SET INDEX COMMANDER INDEX
No.0 No.
• To continue adjusting, press the ID ON button and set
the remote commander's index number to the same as
that of the monitor.
• To cancel adjusting, press the ID OFF button and exit
from the index mode.
1
Setting the index number
The monitor's index number is set to "0" at the time of
delivery.
To adjust a specific monitor, first identify the index number
of the monitor and set the remote commander to the same
number, then begin adjusting.
1 Press the INDEX button on the monitor.
The index number of the monitor appears.
INDEX ON
INDEX
SET INDEX COMMANDER INDEX
No.0
Monitor's index number
2 Press the +/– buttons on the monitor to change the
index number.
3 Press the ID OFF button on the remote commander.
No.
J
EN
D
F
ES
I
11