Safety; Transportation And Handling - Calpeda NCE EI Betriebsanleitung

3.2 Operating conditions
Installation in well ventilated location protected from the weather, with a maximum
ambient temperature of 40 °C.

4 SAFETY

GB
4.1 General provisions
Before using the product it is necessary to know all the safety indications.
Carefully read all operating instructions and the indications defined for the
different steps: from transportation to disposal.
The specialized technicians must carefully comply with all applicable standards
and laws, including local regulations of the country where the pump is sold.
The device has been built in conformity with the current safety laws. The
improper use could damage people, animals and objects.
The manufacturer declines any liability in the event of damage due to
improper use or use under conditions other than those indicated on the
name-plate and in these instructions.
Follow the routine maintenance schedules and the promptly replace
i
damaged parts, this will allows the device to work in the best conditions.
Use only original spare parts provided from Calpeda S.p.A or from an
authorized distributor.
Don't remove or change the labels placed on the device.
Do not start the device in case of defects or damaged parts.
Maintenance operations, requiring full or partial disassembly of the device,
must be done only after disconnection from the supply.
4.2 Safety devices
The device has an external case that prevents any contact with internal parts.
4.3 Residual risks
The appliance, designed for use, when used in-line with the design and safety rules,
doesn't have residual risks.
4.4 Information and Safety signals
For this kind of product there will not be any signals on the product.
4.5 Individual protection devices
During installation, starting and maintenance it is suggested to the authorized
operators to consider the use of individual protection devices suitable for described
activities.
During ordinary and extraordinary maintenance interventions, safety gloves are required.
Signal individual protection device
HAND PROTECTION
(gloves for protection against chemical, thermal and mechanical risks).

5. TRANSPORTATION AND HANDLING

The product is packed to maintain the content intact.
During transportation avoid to stack excessive weights. Ensure that during the tran-
sportation the packed cannot move.
The transport vehicles must comply, for the weight and dimensions, with the chosen
product.
Page 14 / 96 NCE Rev. 3 - Operating Instructions