Hilti HDE 500-A22 Bedienungsanleitung Seite 22

The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise information
Typical A-weighted sound power level (L
Uncertainty for measured sound power level (L
Typical A-weighted emission sound pressure level (K
Uncertainty for the sound pressure level (K
Vibration information
Total vibration (a )
h
Uncertainty (K )
ah
5 Operation
5.1 Comply with all safety instructions and instructions for use.
WARNING
Chemicals hazard Incorrect use can lead to injury.
▶ Prior to use, read and comply with the safety data sheet for the product, the instructions on the packaging
and the instructions for use of the foil pack.
5.2 Inserting the battery
▶ Push the battery into the dispenser from the rear until it engages with an audible click.
5.3 Removing the battery
▶ Remove the battery.
5.4 Inserting the foil pack holder and foil pack
CAUTION
Trap hazard Hands can be trapped if care is not exercised when swiveling the foil pack holder closed.
▶ Keep your hands clear of the cradle area when swiveling the foil pack holder into position.
CAUTION
Risk of injury Chemicals hazard.
▶ Check the foil pack holder for damage and soiling. Both pistons must move smoothly and easily in both
directions over the full length of their travel in the foil pack holder. Replace the foil pack holder if it is
damaged and/or badly soiled.
1. Press the release button.
2. Pull the piston rods back as far as they will go.
3. Fit the foil pack holder and swivel it upwards.
4. Screw the static mixer (mixing nozzle) onto the foil pack.
5. Push the foil pack into the foil pack holder.
6. Swivel the foil pack holder into the dispenser.
14 English
Printed: 27.03.2018 | Doc-Nr: PUB / 5069935 / 000 / 06
)
WA
)
pA
)
pA
2
3
4
)
WA
HDE 500-A22
78 dB
3 dB
67 dB
3 dB
HDE 500-A22
0.5 m/s²
1.5 m/s²
2030483
*2030483*