Connection Diagrams - Gemü 566 Original Einbau- Und Montageanleitung

1. Disconnect the plant from power supply.
2. Unscrew cable entry 1 .
3. Loosen hexagon screws 2 and leave
them in cover of actuator 3 .
4. Remove cover of actuator 3 .
5. Insert cable through cable entry 1,
remove internal sealing ring if necessary.
6. Connect required cables (with an integral
potentiometer, wiring of switches S1 +
S2 on terminals 5-8 is not necessary).
7. Put on cover of actuator 3.
8. Tighten hexagon screws 2.
9. Screw down cable entry 1.
11.3

Connection diagrams

6
1
Pin Designation
1 L, motor voltage
2 N, motor voltage
3 not connected
4 not connected
5 not connected
6 not connected
7 , PE
6
1
Pin Designation
1 L, motor voltage
2 N, motor voltage
3 not connected
4 not connected
5 not connected
6 not connected
7 , PE
566
Connection diagram - Functional module code E1 / E2
5 4
3
2
Connection diagram - Functional module code E3
5
4
3
2
Pin Designation
1 not connected
2 not connected
3 not connected
4 not connected
5 GND, set value input
6 I+ / U+, set value input
7 not connected
Pin Designation
1 not connected
2 not connected
3 GND, actual value input
4 I+ / U+, actual value input
5 GND, set value input
6 I+ / U+, set value input
7 not connected
44 / 64
5 4
6 3
2
1
5
4
6 3
2
1