Transport And Storage; Transportation In A Vehicle - Hilti DSH 700 Bedienungsanleitung

5. Fit the ignition cable connector to the spark plug and hold the threaded section of the spark plug against
the cylinder.
6. Move the start/stop switch to the "start" position.
WARNING
Risk of injury. Touching the electrodes presents a risk of electric shock.
▶ Don't touch the spark plug electrodes.
7. Pull the starter cord (press the decompression valve first).
◁ An ignition spark must now be clearly visible.
8. Use the spark plug wrench to screw the spark plug into the cylinder (tightening torque: 12 Nm).
9. Fit the ignition cable connector to the spark plug.
7.6 Adjusting the carburetor
The carburetor of this product has been factory set for optimum performance and sealed to prevent tampering
(jets H and L). The idling speed of the machine (jet T) may be adjusted by the user. All other adjustments
must be carried out by Hilti Service.
Tampering with the carburetor settings may cause damage to the engine.
▶ Clean the air filter. → page 38
▶ Allow the product to run until it reaches its normal operating temperature.
▶ Use a suitable flat screwdriver (tip width 4 mm/ ⁵/₃₂ ") and do not force the adjusting screw beyond its
intended adjustment range.
▶ Adjust the idling speed jet (T) so that the engine runs smoothly when idling but the cutting disc does not
begin to rotate.
7.7 Care and maintenance of the machine
To help ensure safe and reliable operation, use only genuine Hilti spare parts and consumables. Spare
parts, consumables and accessories approved by us for use with the product can be found at your
local Hilti Center or online at: www.hilti.com
▶ Keep the product, especially its grip surfaces, clean and free from oil and grease.
▶ Do not use cleaning agents containing silicone.
▶ Clean the outer surfaces of the machine at regular intervals with a slightly damp cloth or a dry brush. Do
not use a spray, steam pressure cleaning equipment or running water for cleaning.
▶ Do not allow foreign objects to enter the interior of the product.
7.8 Maintenance
1. Check all external parts of the product and the accessories for damage at regular intervals and check
that all controls operate faultlessly.
2. Do not use the product if parts are damaged or if operating controls do not function faultlessly. Have the
product repaired by Hilti Service.
7.9 Checks after care and maintenance work
▶ After carrying out care and maintenance, check that all protective and safety devices are fitted and that
they function faultlessly.
8

Transport and storage

8.1

Transportation in a vehicle

DANGER
Risk of fire and explosion. If the product tips over during transport, fuel may run out of the fuel tank.
▶ Empty the product's fuel tank completely before packing and shipping it.
▶ Transport the product, as far as possible, in its original packaging.
40 English
Printed: 11.06.2018 | Doc-Nr: PUB / 5265923 / 000 / 05
15
2122988
*2122988*