Setting Up; Initial Settings; Configuring The Network - Sony PWS-100NM1 Handbuch

Setting Up

Initial Settings

Before using the unit, configure the Windows settings
within the unit. The description below describes the
standard settings in Windows 8.
Note
To reboot the unit, first shut down the unit and then turn the On/Standby
button on the front panel on again, without rebooting Windows.
1
Connect a keyboard and mouse to the USB connectors
on the front panel, and connect a monitor to the
DisplayPort connector or HDMI connector on the rear
panel.
2
Set the On/Standby button to the On position.
3
When the Windows sign-in screen appears, enter
"nm1" as the user name, enter "pws100nm1" as the
password, and sign in.

Configuring the network

1
Connect a LAN cable to the LAN connector on the rear
panel of the unit, and connect the other end to the
network.
2
Click [View network status and tasks] under [Network
and Internet] in the control panel.
3
Click [Connections] > [LAN 1/2].
4
Click the [Properties] button.
5
Select [Internet Protocol Version 4 (TCP/IPv4)], then
click the [Properties] button.
6
Change the IP address and other settings.
7
Click the [Advanced] button to configure DNS,
WINS, and other settings.
8
When finished, click the [OK] button.
Setting the date and time
1
Select [Set the time and date] under [Date and Time]
in the [Clock, Language, and Region] control panel.
18
Setting Up
2
Click [Change time zone] on the [Date and Time] tab,
and select the time zone.
3
Click [Change date and time] on the [Date and Time]
tab, and set the date and time.
4
Click the [Change settings] button on the [Internet
Time] tab.
5
Specify an NTP server, then click the [Update Now]
button.
6
Place a check mark in [Synchronize with an Internet
time server] to periodically correct the clock using the
NTP server.
Changing user passwords
The following default users are configured for Windows
within the unit. Change the password for the user to
provide security.
User name Privileges
nm1 Administrator
nm1user General user
Depending on the operating environment, unauthorized
third parties on the network may be able to access the unit.
For security, we strongly recommend changing all the
default passwords as follows.
1
Click [User Accounts and Family Safety] in the
control panel.
2
Click [User Account] > [Change account type].
3
Select the "nm1" or "nm1user" user.
4
Click [Change the password].
5
Enter the current password, a new password and a
password hint, then click the [Change Password]
button.
Signing out
When finished, sign out from Windows.
1
Move the mouse cursor to the top right corner of the
screen to display the Charms bar, then click [Start].
2
Click the account name on the top right of the screen,
then click [Sign out].
Password
pws100nm1
pws100nm1user