Trouble Shooting; Fault Correction - Parkside PAS 1200 A1 Originalbetriebsanleitung

Trouble shooting

Problem
Device does not start
Low or lack of suction
Possible cause
Mains voltage is not present
The equipment is not
switched on
Safety stop due to missing
or incorrectly inserted pleat-
ed filter ( 16) or metal
filter cage ( 17)
Defective on/off switch
( 8)
Defective motor
Suction hose ( 14) or suc-
tion tube ( 15) blocked
The metal container (
is not closed
The metal container (
is full
The pleated filter (
clogged
The air filter ( 19) is
clogged

Fault correction

Check plug socket, power cord,
line, plug and fuse, where ap-
propriate, repair through electri-
cal specialist
Switch on the equipment (see
"Switching on/off")
Insert the pleated filter correctly
(see "Cleaning/Maintenance")
Repair through customer service
Remove obstructions and block-
ages
13)
Close the metal container
13) Empty the metal container (see
"Cleaning/Maintenance")
Clean or replace the pleated
16) is
filter (see "cleaning/mainte-
nance")
Clean the air filter (see "Clean-
ing/Maintenance")
GB MT
39