How Does It Work; Installation - Marmitek iParty Nano Gebrauchsanleitung

How does it work?

Slide the iParty transmitter onto your iPod Nano. Connect the iParty receiver to your audio
system, by plugging the RCA cable of the receiver into one of the audio INs of your audio
system. Connect the power adapter. Set the receiver and transmitter to the same channel.
Place the antenna upright (see step 9) and turn on the transmitter and the receiver. The audio
signal will now be transmitted wirelessly from your iPod Nano to the receiver. The receiver will
transmit the signal on to the audio system.
Operate your iPod Nano as you are used to, and listen to your iPod music via your own audio
system. If the battery in the transmitter is going flat, you can exchange it for the full battery
which has been recharged by the receiver.

Installation

1
2
5
4
4
1. Push open the battery compartment on the Marmitek
iParty Wireless Sender.
2. Insert the supplied rechargeable battery. Observe polarity.
Replace only with NiMH 4/5AAA 1.2V, 400 mAh
rechargeable battery.
3. Attach your iPod Nano to the iParty Wireless Sender by
sliding it on to the jack that fits into your iPod Nano's
headphone socket.
3
4. Set the Channel Switch to match the setting on your
Wireless Receiver.
5. Move the ON-OFF switch to ON.
MARMITEK