Replacing The Lens; Setup And Installation - Cameo SCUBA Bedienungsanleitung

REPLACING THE LENS

Delivery includes two lenses with different beam angles (28° and 40°). To replace a lens, completely disconnect the projector from the
power (remove power plug), loosen the retaining screw (A) in the thread ring, and turn the lens counterclockwise out of the housing. Turn
the desired lens into the housing and secure it using the retaining screw (A). Make sure that the lens is screwed into the threaded ring of the
housing with at least one full rotation.

SETUP AND INSTALLATION

Thanks to the adjustable twin bracket stand, the spotlight can be placed in a suitable location on a flat surface. Install on a crossbeam using a
traverse clamp that is attached to the twin bracket stand (A). Suitable traverse clamps are available as needed. Make sure that the spotlight is
firmly attached and secure it using a suitable safety cable on the provided safety eyebolt (B).
Important safety information: Overhead installation requires extensive experience, which includes calculating the limit
values of the working load of the installation material to be used and regular safety inspections of all installation material and
spotlights. If you do not have these qualifications, do not attempt to carry out the installation yourself; contact a professional
company.
A
B
A
9