ZyXEL G-3000H Schnellstartanleitung Seite 12

Problem
The ETHN LED is off.
I cannot access the
web configurator.
I cannot ping any
computer on the
wireless LAN.
6.1 Procedure to View a Product's Certification(s)
1 Go to www.zyxel.com.
2 Select your product from the drop-down list box on the ZyXEL home page to go to that product's page.
3 Select the certification you wish to view from this page.
Corrective Action
Check the cable connection to the ZyAIR ETHERNET port. Make sure your computer's
network card is working properly.
Make sure the IP addresses and subnet masks of the ZyAIR and the computer are in
the same IP address range. (For example, if the ZyAIR is using the default IP address
and subnet mask, check that the IP address of the computer is in the range 192.168.1.3
~192.168.1.254 and the subnet mask is 255.255.255.0). Refer to the Set Up Your
Computer's IP Address section.
If you changed the ZyAIR default IP address, then enter the new IP address as the web
site address.
The default password is "1234". If you have changed the password and have now
forgotten it, you will need to reset the ZyAIR. Refer to the User's Guide for how to use
the RESET button.
Make sure the ZyAIR is connected to the network.
Make sure you entered your username correctly. A username may be case-sensitive.
If the ETHN LED is off, check the cables between the ZyAIR and your computer or hub.
Verify that the IP address and the subnet mask of the ZyAIR and the computers are in
the same range.
ENGLISH
12