Functional Check - RIB SPARK Wi-Fi Bedienungsanleitung

G
B
DL7
red
S4
PROG.
TX
SPARK Wi-Fi is a flasher managed via radio by the MASTER Wi-Fi card.
CONNECTING THE BATTERIES AND PROGRAMMING
- Remove diffuser (4).
- Remove plastic guard (5).
- Unhook electronic card assembly and battery carrier from plastic base (1).
- Loosen gland bolt of electronic card.
- Remove electronic card to access battery compartment.
- Insert 3 alkaline batteries type C with 1.5V and check the polarities (3 ACG9518).
- Reposition electronic circuit on spacers and fasten screws again.
- Affix plastic base of SPARK Wi-Fi (2) in proximity to automation so it is visible from a
maximum distance of 20 m with respect to the electronic control panel where the MASTER
Wi-Fi card resides.
- Reconnect electronic card assembly and battery carrier to plastic base.
PROGRAMMING
- Press and keep pressed the PROG. RX key on the MASTER Wi-Fi card for at least three
seconds.
- When releasing the PROG. RX key, the bicolor DL7 LED will flash red for 10 seconds.
- Press the S4 PROG. TX key on the SPARK Wi-Fi card to send the radio signal to the
MASTER Wi-Fi.
- Correct memorization is indicated by:
- Buzzer sound;
- On MASTER Wi-Fi card the bicolor red DL7 LED becomes green;
- On SPARK Wi-Fi card the red DL7 LED flashes three times.
- To complete programming, wait for 10 seconds or press the PROG. RX key for an instant
on the MASTER Wi-Fi card.
- Replace protection device (5).
- Mount diffuser (4) and fasten it with the two screws supplied (6).

FUNCTIONAL CHECK

Execute command for the door and check proper functioning of SPARK Wi-Fi.
SPARK Wi-Fi flashes according to the time set on the RIB control panel.
The flashing time is limited to a maximum of 60 seconds.
More than one SPARK Wi-Fi blinker can be memorized by the MASTER Wi-Fi and
will all blink simoultanesly.
NOTE:
CPL1383
BC07064
CVA1962
DAC35X95
PROG. RX
6
3
LED
DRL5X15Z
CPL1381
CPL1380 DAC48X16
DL7 BICOLOR
12/24V ac/dc