Herunterladen Inhalt Inhalt Diese Seite drucken

Precautions For Installation - Citizen CBM-270 Bedienungsanleitung

Inhaltsverzeichnis

Werbung

• Do not use or store the equipment in a place exposed to fire, moisture, or direct sunshine, or in a place
near a heater or thermal device where the prescribed operating temperature and humidity are not met, or
in a place exposed to much oil, iron powder, or dust.
smoke, or catch fire.
• Do not install or use the equipment in a place like a laboratory where chemical reactions are expected,
or in a place where salt or gases are contained in the air.
• Install the printer on a flat, stable desk or table that is free from vibration, in a well-ventilated place.
• Do not install the printer at a location where its operation could be hindered.
• Do not place anything on the printer or leave small objects, like a clip or pin, around it.
object could cause trouble if it gets inside.
• Do not use any sharp-pointed object, such as a pen, for example, to touch the operation panel of the
printer.
It could cause trouble.
• Do not use the equipment near a radio or TV receiver.
radio or TV receiver is connected to.
• Use the equipment only at the specified power supply, voltage and frequency.
smoke and catch fire or cause other problems.
• Connect only the specified power source.
smoke/fire.
• Confirm that a plug socket used for connection has sufficient capacity.
• Avoid connecting a power cable to a plug socket shared by other devices or extending the wiring too far.
It may result in the cable catching fire or a power outage.
force (Pull, load) to the cable, and do not use the printer with such a force applied to it.
• Never connect a grounding cable (Frame ground) to a gas pipe.
When connecting or disconnecting the grounding cable, be sure to disconnect the power cable and the
power plug from the plug socket.
• When connecting/disconnecting the cables, be sure to turn off the power first, including the connected
side, and then connect/disconnect them, holding a plug and a connector.
cause it to snap or become damaged.
• Connect a power cable or a connector cable securely.
internal elements may be broken or a mating device may be adversely affected.
• Use a shielding wire or twisted pair wire for a signal line, in order to minimize noise effect.
route the cable too long or connect it to a noisy device.
erroneous printing due to corrupt data, and so on.
• Use the equipment in an environment where there is a plug socket near the main body and you can
easily disconnect the power plug from it, to shut off the power.
• When the equipment will not be used for a long period of time, unplug it and remove the paper roll from it.
• When transporting the equipment, remove the paper roll from the paper holder.

PRECAUTIONS FOR INSTALLATION

It may cause a reception problem.
The equipment may become out of order, emit
There is a danger of fire or electric shock.
Do not share the power from a plug socket a
Use of an unspecified power source could cause trouble or
Also, do not step on or apply an excessive
If a reverse-polarity connection is made,
Connection to a noisy device could cause
CBM-270 User's Manual
Otherwise, it may emit
There is a danger of explosion.
Pulling the cable itself could
A foreign
Do not
CITIZEN

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis