Werbung
20- SERVOS AND LIKAGES
3mm set Screw
Rudder pushrod
(Or elev. pushrod)
2 mm
Elevator or rudder servo
................3
2x12mm screw
..........6
Connector
........ 3
21- COWLING
2mm
22- BATTERY&FUEL TANK AREA
Right elevator servo (mini servo)
X
3/8 in. (9.5mm)
When you are satisfied with the alignment of the control horn mark the
mounting hole positions with a felt tipped pen or a pencil.
Remove the control horn and drill two 2mm (5/64") holes through the rudder
and elevator.
Attach the rudder and elevators control horn using two 5/64X15/32"(2x12mm)
screws and a back plate.
FUEL TANK OR LI-PO BATTERY AREA
FUSELAGE - TOP VIEW
Apply a thin layer of machine oil or petroleum jelly to only the
top and bottom of the trailing edge of the elevator, then
push the elevator and its hinges into the hinge slots in the
trailing edge of the horizontal stabilizer.
When satisfied with the and alignment, hinge the elevator to
the horizontal stabilizer using CA glue.
Do the same way with the rudder.
Left elevator servo
3/32x13/32"
2.5x10mm.....4
Relieve the cowl to
clear the engine head
Throttle servo hole
Throttle servo hole
Petroleum jelly
Thin CA glue
STABILIZER
Hinge
Rudder servo (mini servo)
2mm
Werbung
