Restoring The Factory Settings - DAB E.SWIM Installations- Und Wartungsanleitungen

3-1 SET8
4-1 External speed
4-1 X1
4-1 X2
4-1 X3
X4
4-1
4-2 Settings
4-3 Inputs
4-4 Outputs
5 Priming
6-1 Anti-Freeze
6-2 Anti-Lock

7.1 Restoring the factory settings

To restore the factory values, switch off the device, wait until the display has switched off completely, press and hold
down simultaneously the two keys "SET1" and "SET4" and turn on the power; release the keys only when the messages
appear on the display.
This restores the factory settings (consisting of a message and a rereading on EEPROM of the factory settings
permanently saved in the FLASH memory and listed in the table above).
Once all the parameters have been set, the device returns to normal operation.
NOTE: this operation obviously deletes all the parameters that have previously been modified by the
operator.
Once the factory values have been restored, it will therefore be necessary to reset all the parameters that
characterise the system, as at the first installation: for the sake of convenience, the system again proposes
the WIZARD (paragraph 4.3).
setpoint Q
setpoint %
type of setpoint
setpoint Q
setpoint %
setpoint Q
setpoint %
setpoint Q
setpoint %
duration
setpoint Q
setpoint %
Config
Source speed
Initial input
Speed mode
IN0 Type – IN4 Type
Config
Type
function
Max Priming Speed
Max Priming Time
function
speed
temperature
function
Table 6 – Factory (default) settings
ENGLISH
25 m3/h 110 GPM
100%
Speed %
5 m3/h 20 GPM
50%
12 m3/h 50 GPM
70%
18 m3/h 80 GPM
85%
25 m3/h 110 GPM
100%
Disable
Digital IN
IN-0
Priority
Normally open
FAULT
Normally open
enabled
100%
10 min
enabled
30%
4°C 40°F
enabled
(*) Factory value on some markets
71