What Is Included - Chauvet DJ Hurricane Bubble Haze Schnellanleitung

What is Included

• Hurricane Bubble Haze
• Power Cord
To Begin
Unpack your Hurricane Bubble Haze and make sure you have received all parts in good condition. If the box or contents
appear damaged, notify the carrier immediately, not Chauvet.
AC Power
This product has a fixed voltage power supply and it can work with an input voltage of either 120 VAC, 60 Hz or 230 VAC,
50 Hz, depending on the specific model.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect the
product from power via breaker or by unplugging it.
Fuse Replacement
1. Disconnect the product from power.
2. Wedge the tip of a flat-head screwdriver into the slot of the fuse holder.
3. Pry the safety cap out of the housing.
4. Remove the blown fuse from the clip on the front of the safety cap and replace with a fuse of the exact same
type and rating.
5. Re-insert the fuse holder and reconnect power.
Mounting
Before mounting this product, read the
above heavy traffic areas, as bubble fluid leaves a slippery surface.
Mounting Diagram
Safety Cable
(such as CH-05 from
Chauvet)
Feet for Surface
Mounting (x4)
FCQ (Fog Cleaner Quart) was specifically developed by Chauvet to clean the hazer mechanism within
the Hurricane Bubble Haze. Make sure you use FCQ regularly, no longer than 90 days between
cleanings, to increase the life of your product.
This product may NOT be tilted. This product should be level at all times.
While operating the Hurricane Bubble Haze, make sure there is adequate fluid in the machine to
prevent pump and heater damage. When the fluid levels become low, simply add more fluids to
continue using the Hurricane Bubble Haze.
• NEVER store this product without cleaning out the bubble mechanism. See
• NEVER leave unused bubble fluid in the reservoir for an extended period. The fluid may thicken in
the reservoir and lead to damage or reduced performance.
Hurricane Bubble Haze QRG Rev. 2
QUICK REFERENCE GUIDE
•
Safety Notes. Ensure that the bubbles are not shooting directly in anyone's face or
Quick Reference Guide
(such as CLP-15 from Chauvet)
EN
Mounting Clamp
M12 Threaded
Mounting Hole
Bubble Cleaning Mode.
2