Werbung
3
3A
3C
Remove the horizontal stabilizer from the fuselage.
Using the sharp hobby knife, carefully cut away the
covering inside the lines which were marked above.
* WARNING: When removing any covering from the airframe,
please ensure that you secure the cut edge with CA or similar
cement. This will ensure the covering remain tight.
Full the elevator out of the
horizontal stabilizer.
When you are satisfied with the alignment,
use a pencil to trace around the top and
bottom of the stabilizer where it meets the
fuselage.
Note: the rectangular hole on the center of the stabilizer
must be coincidental with the center line of the fuselage.
3D
3E
3B
Cut away only
the covering
both side
Werbung
