Preparing Cappuccino - Silvercrest SEM 1100 B3 Bedienungsanleitung

7) Once the cups are filled up to the required amount (about 20 ml per cup),
press the "Espresso" button
You can now drink the espresso.
8) Switch the appliance off with the on/off switch
NOTE
► If no button is pressed, the appliance turns off automatically after 30 minutes.
9) After every use, remove the used espresso powder from the espresso sieve
Remove the sieve holder
blocker
sieve carrier
holder
espresso powder out. Always dispose of the espresso powder in an environ-
mentally friendly manner, e.g. with the organic waste.
NOTE
► Clean the hot water shower
use. See also the section "Cleaning and Care".
NOTE
► Empty the drip tray
in the hole of the drip grille

Preparing cappuccino

Be careful when working with steam for the milk froth production!
The hot steam or hot splashes can lead to injuries!
► Always operate the steam control
1) Fill a container for frothing (preferably made of stainless steel) to one third
with cold milk.
2) Ensure that the steam control
direction " - ").
3) Push the milk frother
SEM 1100 B3
upwards so that the espresso sieve
. Now empty the espresso sieve
and the blocked espresso sieve
regularly, at the latest when the red float
WARNING
to stop the water being pumped through.
from the appliance. To do this, fold the sieve
(the hot water comes out of this) after each
.
slowly.
is closed (turn it as far as it will go in the
out to the side. Always hold it by the handle
.
cannot fall out of the
by turning the sieve
over and knocking the
is visible
│ 79
GB
.
.
■