Water Supply And Drain Connections - Hoshizaki DSM-12CE Bedienungsanleitung

5. WATER SUPPLY AND DRAIN
CONNECTIONS
WARNING
Connect to potable water supply only.
* The connections to the mains water supply
must be made in accordance with the countries'
current requirements of the Water Supply or
Water Fittings Regulations.
* Water supply pressure should be minimum 0.05
MPa (0.5 bar) and maximum 0.78 MPa (8 bar).
If the pressure exceeds 0.78 MPa (8 bar), use a
proper pressure reducing valve. Do NOT throttle
back the supply tap.
* A plumbing permit and services of a licensed
plumber may be required in some areas.
* The ice dispenser drain is gravity flow, so ensure
the outlet hose has an adequate pitch or fall.
* Water should drain into an open trap.
* Be sure to use the new hose-sets supplied with
the appliance. Do not reuse any old hose-sets.
1) Attach angled end of white inlet hose (accessory)
to the G3/4 fitting on the rear of the ice dispenser
as indicated ensuring rubber sealing washer is
correctly positioned. Hand tighten sufficiently to
provide leak free joint.
2) Attach the other end of inlet hose to the water
tap, noting washer is correctly positioned before
hand tightening as above.
3) By means of a suitable spanner or wrench,
tighten the Rc1/2-G3/4 nipple (accessory) into
the R1/2 fitting on the rear of the ice dispenser
as indicated. P.T.F.E. tape and/or a suitable
sealing compound should be used to obtain a
leak free joint.
Note: Jointing compounds should be approved
and suitable for potable water use.
4) Attach grey flexible outlet hose (accessory)
to free end of Rc1/2-G3/4 nipple as indicated,
confirming fitment of rubber washer before finally
hand tightening the joint. This hose can be cut
to length as necessary to suit position of main
drain.
II. OPERATING INSTRUCTIONS
WARNING
1. This ice dispenser is designed to produce
and store edible ice. To keep the ice
dispenser hygienic:
* Keep the grille clean. Clean it by using a
neutral cleaner and rinse thoroughly.
2. T h e u s e o f a n y e l e c t r i c a l e q u i p m e n t
i n v o l v e s t h e o b s e r v a n c e o f s o m e
fundamental rules. In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in doubt,
disconnect the ice dispenser.
* Do not pull the power cord in order to
disconnect the ice dispenser from the
feed network.
* This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
3
ENGLISH
Water Supply Inlet
G3/4
Inlet Hose
Drain Outlet R1/2
Rc1/2-G3/4 Nipple
Outlet Hose
Fig. 3
Water Supply Tap
Inlet Hose
Fig. 4