Inset Ceiling Mounting - Axis 231D Installationsanleitung

Inset Ceiling Mounting

AXIS 231D mounted in bracket
Detail - network connector:
Follow these instructions to mount the dome camera:
1. Place the decoration ring on the ceiling and mark the three screw holes and the inner
circle of the decoration cover.
2. Cut the hole in the ceiling according to the markings.
3. Insert the mounting bracket in the ceiling with the holders folded in. Once in place,
fold out the holders over the inner ceiling and secure the bracket by tightening the
screws.
4. Connect the Ethernet cable and connection module to the AXIS
231D/232D.
5. Connect the power cable and check that the power and network
LEDs light up (green).
6. Push the dome body up into the installed bracket and twist it
clockwise to lock it into the bracket.
7. Make sure the screw hole on the side of dome is aligned with the
bracket. Tighten the fixing screw to secure the dome.
8. The hardware installation is now complete, proceed to the next
section to install the AXIS 231D/232D on your network.
Connection
module
connector
Network
connector
Network
Indicator
Power
Indicator
Installing the AXIS 231D/232D
Fixing screw
Ceiling
Decoration ring
7