Radio Operation - nedis RDFM5000BN Anleitung

Important
• If the device is operated exclusively with AC power or during non-use of more than one
month, please remove the batteries in order to avoid any damage by leaking batteries.
• Replace the batteries if the volume of the device becomes lower or the sound becomes
distorted.
Battery Safety Precautions
• Follow the battery manufacturer's safety, usage and disposal instructions.
• Only use batteries of the same type and size.
• Insert the batteries observing the polarity (+/–). Failure to properly align the battery
polarity can cause personal injury and/or property damage.
• Do not mix battery types (e.g. alkaline, zinc/carbon, rechargeable batteries) or exhausted
and new batteries.
• To avoid fire and explosion do not recharge normal batteries. Keep batteries away from
children and pets.
• We recommend the use of alkaline batteries for a longer lifetime of the batteries.
Mains operation
The device is designed for mains power supply AC 230 V~50 Hz. Do not connect the device to
any other power supply to avoid damage that is not covered by your warranty.
1. Connect the smaller plug to the AC socket at the rear of the device. Make sure that the
plug is completely inserted.
2. Insert the mains plug to a wall outlet.
3. Disconnect the Power cord from the mains when the device is not used.
GENERAL OPERATING INSTRUCTIONS
On/Off
Switch on the device by turning the volume control Volume clockwise, until you overcome
the point of resistance.
Switch of the device by turning the volume control Volume anti-clockwise, until you
overcome the point of resistance.
Volume control
Increase or decrease the volume by rotating the volume control Volume to the left or right.

RADIO OPERATION

Select with the FM, MW buttons to choose your desired frequency band.
Advice for better reception
• FM: Fully extend the telescopic antenna and turn it for better reception.
• MW: The device has a built-in antenna. Change the position of the device if reception is
poor.
Frequency adjustment
• Tune in the desired station by rotating the frequency scale. Rotating clockwise increases
and rotating counter clockwise decreases the frequency.
• The current adjusted frequency for selected band can be read on the frequency scale.
7
ENGLISH