System Bios - Dell EMC PowerEdge M640 Installations- Und Servicehandbuch

Option Description

System BIOS

Enables you to configure BIOS settings.
iDRAC Settings Enables you to configure the iDRAC settings.
The iDRAC settings utility is an interface to set up and configure the iDRAC parameters by using UEFI (Unified
Extensible Firmware Interface). You can enable or disable various iDRAC parameters by using the iDRAC settings
utility. For more information about this utility, see Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
Device Settings Enables you to configure device settings.
System BIOS
You can use the System BIOS screen to edit specific functions such as boot order, system password, and setup password, set the SATA
and PCIe NVMe RAID mode, and enable or disable USB ports.
Viewing System BIOS
To view the System BIOS screen, perform the following steps:
Schritte
1. Power on, or restart your System.
2. Press F2 immediately after you see the following message:
F2 = System Setup
ANMERKUNG: If the operating system begins to load before you press F2, wait for the System to finish booting, and
then restart the System and try again.
3. On the System Setup Main Menu screen, click System BIOS.
System BIOS Settings details
About this task
The System BIOS Settings screen details are explained as follows:
Option Description
System Provides information about the System such as the System model name, BIOS version, and Service Tag.
Information
Memory Settings Provides information and options related to the installed memory.
Processor Provides information and options related to the processor such as speed and cache size.
Settings
SATA Settings Provides options to enable or disable the integrated SATA controller and ports.
NVMe Settings Provides options to change the NVMe settings. If the system contains the NVMe drives that you want to
configure in a RAID array, you must set both this field and the Embedded SATA field on the SATA Settings
menu to RAID mode. You might also need to change the Boot Mode setting to UEFI. Otherwise, you should set
this field to Non-RAID mode.
Boot Settings Provides options to specify the Boot mode (BIOS or UEFI). Enables you to modify UEFI and BIOS boot settings.
Network Settings Provides options to manage the UEFI network settings and boot protocols.
Legacy network settings are managed from the Device Settings menu.
Integrated Devices Provides options to manage integrated device controllers and ports, specifies related features and options.
Serial Provides options to manage the serial ports, their related features and options.
Communication
Pre-operating system management applications 25