Preparing For Use; Assembling The Breast Pump - Philips AVENT SCD293 Bedienungsanleitung

English
8
Caution
-
The breast pump is only intended for repeated use by a single user.
-
Never drop or insert any foreign object into any opening.
-
Never use any accessories or parts from other manufacturers or that Philips Avent does not
specifically recommend.
-
Wash, rinse and disinfect all pump parts before each use.
-
Do not use antibacterial or abrasive cleaning agents when you clean breast pump parts.
-
Do not continue pumping for more than five minutes at a time if you do not succeed in
expressing any milk.
-
If the pressure generated is uncomfortable or causes pain, break the seal between the breast and
the pump body with your finger and remove the pump from your breast.

Preparing for use

Clean and disinfect all parts of the breast pump before first use in the correct way (see 'Cleaning
and disinfection'). Clean all parts after each subsequent use and disinfect all parts before each
subsequent use.

Assembling the breast pump

Note: Make sure you have cleaned and disinfected all parts of the breast pump. Wash your hands
thoroughly before you handle cleaned parts.
Warning: Be careful, the cleaned parts may still be hot. Only start assembling the
breast pump when cleaned parts have cooled down.
Tip: You may find it easier to assemble the breast pump while it is wet.
1 Insert the white valve into the pump body from underneath. Push the valve in as far as possible
(Fig. 2).
2 Screw the pump body clockwise onto the bottle (Fig. 3) or storage cup (Fig. 4) until it is securely
fixed.
Note: If you use a storage cup, you have to screw the adapter ring onto the storage cup first (Fig. 4).
3 Insert the silicone diaphragm into the pump body from above. Make sure it fits securely around
the rim by pressing down with your fingers to ensure a perfect seal (Fig. 5).
4 Attach the handle onto the diaphragm with stem by hooking the hole in the handle over the end
of the stem. Push down the handle onto the pump body until it clicks into place (Fig. 6).
5 Place the massage cushion into the funnel-shaped section of the pump body (Fig. 7). Push in the
inner part of the massage cushion as far as possible and make sure that it is perfectly sealed all
around the rim of the pump body (Fig. 8). Press in between the petals to remove any trapped air
(Fig. 9).
Note: Place the cover over the massage cushion to keep the breast pump clean while you
prepare for expressing.
Warning: Always use the breast pump with a massage cushion.