Fine-Adjusting And Adjusting The Table Height At Body Base Assemblies; Cube-Container Cable Management - VS Vereinigte Spezialmöbelfabriken 901 serie Montageanleitung

(3)
(1)
11. Fine-adjusting and adjusting the
table height at body base assemblies.

Cube-container cable management.

Fine adjustment at fixed-height upright containers, cube
containers and sideboards.
The cube container has height-compensating screws (1).
10 mm vertical travel. Use a VS special wrench (= offset
engineer's wrench) (3).
Adjustment the table heights at cube containers and
sideboards.
Insert the crank handle in the designated hole in height-ad-
justment tube (3) (cube container interior) and turn clock-
wise or counterclockwise until the desired table-top height
is set. The set height can be read off on the measurement
scale (6) of the inner tube.
34
(6)
(2)
(4)
(5)
Cube-container cable management.
The top surface features a cable outlet (4), through which
the cables can be fed into the interior of the cube container.
On the back there is between the door and the body a
mount (5), to which the assorted cables can be secured.
Caution! Do not coil the electrical cable excessively
when using. This creates the danger of a build-up of
heat. Consult a qualified electrician or uncoil the cable
so that it is only coiled a few turns.