Muller-Licht tint Bedienungsanleitung Seite 40

• Think beforehand about which bulbs you want to group together and try to make the
groups logical and comprehensible. This means you will be able to use the groups
later using the group button quickly and without having to waste time testing them.
Using the group button
• The first time the group button is pressed, the LEDs above it will show which group
you are in.
• Pressing it again will advance you one group.
• You are in the next group when the following LED above the group button lights up:
° LED 1 for the first group
° LED 2 for the second group
° LED 3 for the third group
° LED 1, 2 and 3 for all groups
Using the group button
• The first time the group button is pressed, the LEDs above it will show which group
you are in.
• Pressing it again will advance you one group.
• You are in the next group when the following LED above the group button lights up:
° LED 1 for the first group
° LED 2 for the second group
° LED 3 for the third group
° LED 1, 2 and 3 for all groups
Adding a new bulb
• Take note of the technical specifications when purchasing new bulbs. We recom-
mend tint bulbs from Müller-Licht. When using bulbs made by other manufacturers,
it is not guaranteed that all features will be supported or will work as intended.
• If you are using a white tint bulb that only emits white light, the coloured light
features will not be available. The bulb will be switched off.
1. Unplug the lamp at the mains, remove the old bulb and screw the new tint bulb into
the socket.
2. Plug the lamp back in at the mains and set the corresponding light switch to I or
ON.
The new bulb will signal that it is in coupling mode by briefly increasing and decre-
asing its brightness and changing colour if applicable. If this does not occur, switch
the bulb off and on again 5 times.
3. Press the group button repeatedly until all the LEDs above the group button light up.
tint-REMOTE CONTROL
INSTRUCTION MANUAL
40