Silvercrest SBLP 4.2 A1 Bedienungsanleitung Und Sicherheitshinweise Seite 46

SilverCrest SBLP 4.2 A1
select device 'SBLP 4.2 A1' and establish the connection. Enter '000' if
you are asked for a PIN.
 The speaker emits an acoustic signal to confirm the setup of the
connection, and the Operating LED (7) is lit blue.
 Adjust the volume on your audio source or using the - button (4) and
+button (5). Hold down the buttons to do this.
 You can switch off the speaker by holding down the on/off button (1) for
approximately two seconds. You will hear an acoustic signal that
gradually decreases in volume.
While operating in Bluetooth
following functions:
Function
Playback/pause
Next track
Previous track
Go to start of track
Volume up*
44 - English
®
mode, the buttons on the speaker perform the
Action
Briefly press the on/off button (1)
Briefly press the + button (5)
Press the - button (4) twice with a
short pause
Briefly press the - button (4)
Hold down the + button (5)