Liability Exclusion - Renfert Pillo Bedienungsanleitung

• Use only compressed air to power the
unit.
• Always disconnect the unit from the
compressed air supply before exchanging
or replacing chisel inserts! There is a sig-
nificant risk of injury should the Renfert
deflasking chisel start unexpectedly.
• Always disconnect the unit from the com-
pressed air supply before beginning any
maintenance tasks!
• Regularly examine the connecting hoses
for damage (e.g., kinks, cracks, porosity).
• Never operate a unit with damaged con-
necting hoses or other defects!
• Health risk due to vibrations (hand-arm-
vibrations).
• It is the responsibility of the operator that
national regulations during operation and
regarding a repeated safety inspection of
electrical equipment are complied with.
For Germany these are the regulation 3
by DGUV (German Statutory Accident
Insurance) in relation with VDE 0701-0702
(Association for Electrical & Electronic
Technology).
• Only spare parts and accessories sup-
plied or authorized by Renfert GmbH may
be used with this product. If other spare
parts or accessories are used, this could
have a detrimental effect on the safety of
the device, increase the risk of serious
injury and lead to damage to the environ-
ment or the device itself.
• Information on REACH and SVHC is avail-
able on our website www.renfert.com, in
the Support area.

3.3 Liability Exclusion

Renfert GmbH shall be absolved from all claims
for damages or warranty if:
• The product is employed for any purpos-
es other than those cited in the operating
instructions;
• The product is altered in any way other
than those alterations described in the
operating instructions;
• The product is repaired by other than an
authorized facility or if any but Renfert
OEM parts are employed;
EN
• The product continues to be employed,
despite obvious safety faults or damage;
• The product is subjected to mechanical
impacts or is dropped.
4. Commissioning
We recommend the installation of an upstream
filter pressure regulator.
Note the connection pressure! The
pressure available from a com-
pressed air network or set at a
maintenance unit may not exceed
the maximum level specified in the
technical specifications.
Use only compressed air to power
the Renfert deflasking chisel.
• Switch the Renfert deflasking chisel off at the
ball valve (turn the valve clockwise to its stop,
Figure 1).
• Attach the connecting hose to the Renfert
deflasking chisel (Figure 2).
.• In order to access the compressed air net-
work, take the compatible tube coupler from
the enclosed set and place on the end of the
tube. (Figure 3).
In addition:
- Unscrew the coupling ring from the con-
necting plug.
- Push the coupling ring over the connection
tube.
- Connect the connecting tube with the con-
nection plug and secure with the coupling
ring.
• Attach the connecting hose to the com-
pressed air supply (Figure 4).
The filter housing (Figure 7) must
not be removed from the connecting
tube. These will help maintain the
filter and will protect your Renfert
deflasking chisel against dirt and
other contaminants.
Never use an oil atomiser!
The Renfert deflasking chisel is
maintenance-free. An oil atomiser
will produce resinous deposits in the
motor or block the filter!
- 2 -