Symbols Used In This Manual; Symbols On The Power Tool; For Your Safety; Intended Use - Flex BSE 14-3 100 Originalbetriebsanleitung

Contents
Symbols used in this manual . . . . . . . . . 16
Symbols on the power tool . . . . . . . . . . . 16
For your safety . . . . . . . . . . . . . . . . . . . . 16
Noise and vibration. . . . . . . . . . . . . . . . . 19
Technical specifications . . . . . . . . . . . . . 20
Overview . . . . . . . . . . . . . . . . . . . . . . . . 21
Instructions for use . . . . . . . . . . . . . . . . 22
Maintenance and care . . . . . . . . . . . . . . 26
Disposal information. . . . . . . . . . . . . . . . 27
-Declaration of Conformity . . . . . . . . . 27
Exemption from liability . . . . . . . . . . . . . 27

Symbols used in this manual

WARNING!
Denotes impending danger. Non-
observance of this warning may result
in death or extremely severe injuries.
CAUTION!
Denotes a possibly dangerous situation.
Non-observance of this warning may result
in slight injury or damage to property.
NOTE
Denotes application tips and important
information.

Symbols on the power tool

Before switching on the power
tool, read the operating manual!
Wear goggles!
Protection class II
(completely insulated)
Disposal information for the old
machine (see page 27)
16

For your safety

WARNING!
Before using the angle grinder, please read
and follow:
these operating instructions,
-
the "General safety instructions" on the
-
handling of power tools in the enclosed
booklet (leaflet-no.: 315.915),
the currently valid site rules and the
-
regulations for the prevention of
accidents.
This angle grinder is state of the art and has
been constructed in accordance with the
acknowledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged. The angle
grinder may be operated only if it is
as intended,
-
in perfect working order.
-
Faults which impair safety must be repaired
immediately.

Intended use

The drive unit BME 14-3 L must be used
solely as a drive for the attachments
described below.
With the burnishing attachment
BSE 14-3 100 /
BBE 14-3 110
tool is intended
- for commercial use in industry and trade,
- for the machining of surfaces, such as the
satinising, structuring, polishing,
brushing, smoothing, derusting or
deburring of steel, stainless steel or non-
ferrous metals,
- for use with tools which are offered for this
machine by the manufacturer.
It is not permitted to machine the surface of
wood.
With the belt sander attachment
BRE 14-3 125 the power tool is
intended
- for commercial use in industry and trade,
- for finishing stainless steel pipes, round
railing parts,
- for sanding round bar profiles as well as
pipes in general,
TRINOXFLEX
the power