Husqvarna FS5000 D Bedienungsanweisung Seite 39

8. Adjust the resistance on the lever for speed control
with the nut on the side of the lever for speed
control.
To move the product up and down a ramp
WARNING: Be very careful when you move
the product up and down ramps with the
engine on. The product is heavy and there is
a risk of injury if the product falls or moves
too quickly.
WARNING: For ramps with a large angle,
always use a winch. Do not walk or stay
below the product.
• To move the product down a ramp, operate the
product rearward slowly.
• To move the product up a ramp, operate the product
forward slowly.
To move the product with the engine off
1. Turn the engine start switch to ignition on position
(A).
2. Push the switch for cutting depth adjustment (B) up
until the cutting blade does not touch the ground.
1143 - 002 - 08.07.2019
A
B
3. Put the lever for speed control into the stop position.
4. Turn the transmission bypass valve
counterclockwise to the end position to disengage
the transmission.
5. Hold the operation handles and push the product to
move it.
WARNING: Do not push the product on
a slope while the transmission bypass
valve is in neutral position. The product
can move away from you and cause
injury to bystanders.
To lift the product
WARNING: Make sure that the lifting
equipment has the correct dimension. The
type plate on the product shows the product
weight.
WARNING: Do not lift a damaged product.
Make sure that the lifting eye is correctly
installed and not damaged.
WARNING: Do not walk or stay below or
near a lifted product.
CAUTION: Do not use the operation handles
to lift the product.
39