Stahl 9475/32-08-.2 series Betriebsanleitung Seite 42

Technical Data
EN
Technical Data
EN
Indication
EN
LED indication
EN
Module requires
EN
maintenance
EN
Operating state
EN
Group error
Channel error
EN
Channel status
EN
"Plant STOP"
EN
Function indication
EN
Retrievable
EN
parameters
EN
Error indication
EN
Module status and
alarms
EN
EN
EN
EN
Signal errors for
EN
each channel
EN
Signal status bit "0" = output high-impedance / "1" = output is supplied
EN
Wire breakage
EN
output
EN Short circuit
output
EN
Mounting / Installation
EN
Mounting orientation
Mounting type
For further technical data, see r-stahl.com.
16
Digital Output Module 8-Channel Version
for Zone 1
Series 9475/32-08-.2
LED "M/S", blue
LED "RUN", green
LED "ERR", red
LED red, for each channel
LED yellow, for each channel
LED yellow ("Plant STOP" active, all outputs are high-impedance)
Manufacturer, Type, hardware revision, software revision, serial number
• Internal bus error primer / redundant
• No response from IOM
• Configuration does not correspond to the module
• Hardware error
• Excess temperature
• Slot error
• Module requires maintenance
> 12 kΩ
(with deactivated test current can be detected only if the output is switched on)
< 30 Ω (response range 30 to 60 Ω)
(can be detected only if the output is switched on)
horizontal or vertical (observe operating instructions)
on 35 mm DIN rail NS 35/15 (DIN EN 60715)
218139 / 9475611310
2019-01-18·BA00·III·en·02