Hilti SID 4-A22 Original Bedienungsanleitung Seite 30

1. Fit the belt hook.
2. Attach your power tool to the belt hook.
3. Check that belt hook and power tool are secure.
5.5 Fitting an accessory tool
1. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the
connection end if necessary.
3. Push the accessory tool into the chuck as far as it will go (until it engages).
4. Check that the accessory tool is held securely.
6 Types of work
ATTENTION
Risk of damage by incorrect handling!
▶ Do not operate the switches for direction of rotation and/or function
selection during operation.
Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Setting the torque
▶ Push the torque selector button repeatedly until the desired torque setting
is displayed in the torque display.
6.2 Setting forward or reverse rotation
▶ Set the forward/reverse switch to the desired direction of rotation.
➥ The control switch is locked when the forward/reverse switch is in the
middle position (safety lock). An interlock prevents switching while the
motor is running.
6.3 Switching on
▶ Press the control switch.
➥ Speed of rotation is regulated by the distance the control switch is
pressed in.
6.4 Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be
damaged if torque is too high. This presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced
by the tool.
24 English
Printed: 20.02.2019 | Doc-Nr: PUB / 5293888 / 000 / 05
3
5
6
2145524
*2145524*