Hilti TE 30-AVR Original Bedienungsanleitung Seite 20

Total vibration
Hammer drilling in concrete (a
Chiseling (a )
h, Cheq
Uncertainty (K)
5 Operation
Fitting the side handle
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the
clamping band is engaged in the groove provided on the tool.
Fitting / removing the chuck
CAUTION
Risk of injury! The depth gauge, if fitted but not used, may hinder the user.
▶ Remove the depth gauge from the tool.
Note
The function selector switch should be set to the
the chuck.
Fitting / removing the accessory tool
Note
Use of unsuitable grease may cause damage to the product. Use only the
recommended grease supplied by Hilti.
Adjusting the depth gauge
Drilling without hammering
Drilling with hammering action (hammer drilling)
TE 30-C-AVR
Chisel positioning
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the
function selector switch until it engages in the "Chiseling" position.
Note
The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that
flat chisels and shaped chisels can always be set to the optimum working position.
TE 30-C-AVR
Chiseling
Forward / reverse
Note
Operate the forward / reverse selector switch only when the motor has stopped.
14 English
Printed: 29.05.2017 | Doc-Nr: PUB / 5070837 / 000 / 04
TE 30
) 16.5 m/s²
h, HD
•/•
1.5 m/s²
TE 30­AVR
12 m/s²
•/•
1.5 m/s²
"Chiseling" position when changing
TE 30­C­AVR
12 m/s²
11 m/s²
1.5 m/s²
2
3
4
5
6
6
6
6
7