Operation; Cleaning And Maintenance - CMi C-B-46 Originalbetriebsanleitung

Rasenmaeher_Benzin_401165.book Seite 43 Freitag, 8. April 2016 2:32 14

Operation

Check before starting the device!
DANGER! Risk of injury! The
device may only be put into opera-
tion if there are no defects. If a part is
defective it must be replaced before
the device is used again.
Check to make sure the device is in safe
operating condition:
– Check to make sure there are no visible
defects.
– Check to make sure all device compo-
nents are correctly mounted.
Starting the motor
► P. 3, item 2
DANGER! Danger of fire! Spilled
fuel can set the product on fire.
Carefully wipe up any spilled fuel up
before starting.
Start the product a minimum of nine
metres away from where you filled it.
Note: In case of start-up difficulties,
please refer to the following able:
► Troubleshooting – p. 45
– Slightly press fuel pump (11) approx. 3–
5×.
– Engage and firmly hold throttle (1) up to
the stop.
– Slow pull out the pull starter (9) until you
feel a resistance, then quickly and force-
fully, until the initial ignition noise can be
heard.
– Pull out the pull starter again quickly and
forcefully until the motor starts up.
Switching off the motor
► P. 3, item 2
WARNING! Risk of injury! Always
switch off the product when not in
use for short periods.
– Release the throttle (1).
Mowing
DANGER! Risk of injury! Before
starting work, check the area and
remove all objects which may be
kicked up by the unit.
– Guide the unit at an even, slow pace
(walking speed) and with as straight a
path as possible.
Important notes
• Always work at right angles to the slope.
• Try not to cut grass when wet.
• Use overlapping paths to produce an
even cutting pattern.
• Cut longer grass with a greater cutting
height initially, then cut crosswise using
the desired cutting height.

Cleaning and maintenance

DANGER! Risk of injury! Carry out
the maintenance work described
here in person.
Improper maintenance work can
damage the device and lead to inju-
ries.
DANGER! Risk of injury! Prior to
conducting maintenance or cleaning:
– Switch-off the device.
– Allow for the device to cool down.
– Disconnect the ignition cable.
Cleaning and maintenance overview
Before each use
What? How?
General function Visual check.
check.
Check all screw Hand-tighten the screw
connections and connections using the
tighten if neces- appropriate tool.
sary.
Check cable of the Visual inspection.
pull-starter for
damage
► Checking the level of
Check motor oil
level motor oil – p. 44
After each use
What? How?
► Cleaning the device –
Cleaning the de-
vice p. 44.
Every 25 hours of operation
What? How?
► Cleaning the spark
Cleaning the spark
plug plug – p. 44,
► Replacing the air fil-
Replacing the air
filter ter – p. 44
GB
43