Princess Starck 6002 Anleitung Seite 7

Starck_6002_IB_22-3-04 3/22/04 3:34 PM Page 7
GETTING TO KNOW YOUR 3-IN-1 CURLING IRON SET
(Product may vary slightly from illustration)
1. Cool Safety Tip
2. Ready Dot
3. Clamp Release Lever
4. On/Off switch
5. Handle
6. Power Indicator Light
7. Locking Ring
8. Medium Iron
9. Large Iron
10. Spiral Iron
HOW TO USE YOUR INTERCHANGEABLE CURLING IRON WANDS
Use the Storage Box / Stand to keep your Curling Iron Wands at your convenience.
IMPORTANT:
During the first few minutes of initial use, you may notice smoke and a slight odour. This is normal
and will quickly disappear.
WARNING: The barrel of this curling iron is hot. Care should be taken when using.
• Keep unit away from contact with all skin areas. Do not touch iron barrel with fingertips.
• For shorter hair, place a thin plastic comb between scalp and Curling Iron barrel to avoid
touching scalp.
• Test on a small section of hair before using.
TO CHANGE CURLING IRON WANDS
ALWAYS BE SURE CURLING IRON IS COOL BEFORE CHANGING WANDS.
Turn the locking ring in the direction of the arrow shown to release iron. Replace iron by inserting
iron into the handle, and turning the handle to lock.
TO USE CURLING IRON WANDS
Choose the particular wand you wish to style your hair with, depending on the effect you wish to
achieve. For a complete styling, hair should be clean, dry and free from dirt, hair spray, creams, etc.
(This iron can also be used for quick touch-ups at any time.)
PRE-HEAT
Rest the Curling Iron in its stand, on a smooth, and heat resistant, flat surface. Plug the unit into a
230V AC electrical outlet. Slide the ON/OFF button to the ON position and allow iron to heat. The
power indicator light will come on, letting you know the unit is operating. When cool, the READY
dot on the clamp release lever 'tongue tip' will be black. When hot, the dot will glow red.
1. power indicator light
2. when hot, the READY dot is red
3. when cool, the READY dot is black
7